Homeowner resources.
Everything you need, before, during, and after your project.
What to Expect
A clear look at your project, from the door-removal visit to the final walkthrough.
Read onlineDay of Removal (PDF)On-Site Schedule (PDF)Day of Installation (PDF)
Cabinet Care
Simple habits that keep your new finish looking its best.
Warranty and Specifications
Our warranty and our standard specifications, to read before you decide.
What Photos to Send
Exactly what our photo app will ask for, so you can get ready.
Read onlineSee the photo instructions in the appDownload PDF
What to Expect
A clear look at your project, from the door-removal visit to the final walkthrough.
Day of Removal (PDF)On-Site Schedule (PDF)Day of Installation (PDF)
The project at a glance
The door-removal visit takes about 90 minutes and usually happens 3 to 5 days before on-site finishing begins. The on-site work typically takes four days. We provide a schedule before work begins, so you know when each phase will happen.
Payment: 50% of the quote total is due on the day of removal, and the remaining 50% is due on the day of installation.
Day of removal
Most cabinets can stay full. You can leave items inside cabinets and most drawers. If a drawer front does not come off the drawer box, empty that drawer first.
We label every door and drawer front, along with every hinge and related part, and carefully remove them so each piece returns to its original place. The visit is typically 90 minutes or less. Doors and drawer fronts then go to our facility for prep and spray.
The typical four-day on-site schedule
- 1
Day 1: Set up and protect
We arrive and set up equipment, protect floors, counters, and nearby areas, and mask the kitchen for spraying.
- 2
Day 2: Prep the boxes
We degrease cabinet boxes and frames, sand and complete any repairs, and give everything a final wipe-down before finish.
- 3
Day 3: Spray and reset
We spray seal coats and finish coats, unmask, reinstall drawer boxes and glides, and clean the work area.
- 4
Day 4: Install and hand off
Finished doors and drawer fronts go back on, hardware is installed and alignment is set, and we finish with a final inspection, cleanup, and handoff with you.
Day of installation
Doors and drawer fronts go back to their labeled locations. Pulls are installed as specified, and bumper pads are added where doors and drawers meet another surface. Doors, hinges, drawer fronts, and gaps are adjusted for clean, even alignment. We complete touch-ups, clean the work area, and inspect the finished cabinetry.
What we leave with you:
- Labeled touch-up paint
- Cabinet care instructions
- Warranty documentation
- Your final invoice
A walkthrough is helpful if you can be there. It is not required if we already have access and lock-up instructions. Payment is due upon receipt of the invoice we leave with you.
Dust, odor, and daily life
Some odor and dust are normal during finishing. We contain both as tightly as we can. Your kitchen stays usable, except while we spray the finish coats, and you can use it again the same day. Tell us in advance about kids, pets, or sensitivities and we will plan around them.
The finish is dry to the touch in about 30 minutes and hard dry in 12 to 18 hours. Full cure takes 3 to 7 days, and we ask you to treat the cabinets gently for the first 10 days. See our Cabinet Care Guide.
Hardware
You choose and supply your pulls. We lay them out, bore, and dry-fit them before the final finish coats, then install them after your doors and drawers are back in place. We supply soft-close hinges sized to the required overlay, in standard and premium options, and bore new hinge cup holes as needed.
The first 10 days matter
Your professional cabinet coating continues to cure after installation. It is hard dry in 12 to 18 hours and fully cured in 3 to 7 days. Treat the finish gently for the first 10 days so it can develop its intended hardness and durability.
- Use the hardware. Open doors and drawers by the knobs or pulls, never by the freshly finished surfaces.
- Keep it dry. Wipe spills promptly, and do not leave wet towels, standing water, or damp items against cabinetry.
- Clean lightly. When needed, use only a soft microfiber cloth lightly dampened with warm water, then dry immediately.
- No harsh cleaners. During cure, avoid multipurpose cleaners, sprays, polishes, waxes, ammonia, bleach, and silicone.
Everyday cleaning
- Use a soft, lint-free microfiber cloth.
- For light cleaning, use warm water or a small amount of mild dish soap.
- Work in small areas, and dry the surface immediately with a clean, soft cloth.
- Wipe food, grease, and spills promptly, especially around sinks, dishwashers, and cooking areas.
Never spray cleaner directly onto cabinet doors, drawer fronts, frames, or finished end panels. Apply moisture to the cloth, not the cabinetry.
Do not use
- Ammonia or bleach
- Multipurpose or aerosol cleaners
- Wax, polish, or silicone products
- Abrasive pads, scrub brushes, or magic-eraser-type abrasives
- Harsh solvents or aggressive degreasers
- Sharp objects or scraping tools
Protect the cabinetry
- Maintain indoor relative humidity around 35 to 50% when practical.
- Use your knobs and pulls to reduce hand oils and wear on doors and drawer fronts.
- Protect surfaces from sharp impacts, abrasive tools, excessive heat, and prolonged moisture.
Good to know
Wood naturally expands and contracts as humidity changes. On painted doors and drawer fronts, a fine hairline may occasionally become visible at a wood joint. This is cosmetic and does not indicate a failure of the coating or the cabinet structure.
Sheen can look slightly uneven for the first few weeks while the coating finishes curing, and a faint finish odor may linger briefly. Ventilate the room normally.
If something looks off
Stop cleaning and reach out before trying another product. A quick photo of the area helps us diagnose it faster. If you are unsure whether a cleaner or care method is safe, contact us before using it: 219.299.0080 or info@finefinishesusa.com.
Warranty and Specifications
Our warranty and our standard specifications, to read before you decide.
Our Lifetime Warranty
Our craftsmanship is our quality assurance pledge. Our Lifetime Warranty is documented as a Limited Lifetime Workmanship Warranty, and you can read the complete terms here: what it covers, what it does not, how to care for your cabinets, and how to make a claim.
It applies to the original purchaser, for as long as they own the home, and it is not transferable.
Standard specifications
The specifications we include with every proposal describe our preparation, priming, finishing, color and sheen, hardware and reassembly, and quality control.
What Photos to Send
Exactly what our photo app will ask for, so you can get ready.
The easiest way
Use our photo app. It walks you through each area, one at a time, and saves as you go, so you can finish later. Take photos with your camera, or choose them from your gallery.
Good photos let us prepare an accurate written proposal without a visit. Take each wall straight on and as flat as you can, and take each section up close, so every door and drawer can be counted and labeled.
Kitchen cabinets (at least 6 photos, up to 12)
- The whole kitchen from the doorway.
- Each wall of cabinets straight on and as flat as you can, one photo per wall.
- Each section of cabinets up close, so every door and drawer can be counted and labeled.
- One door up close, showing its edge and finish.
- An end panel and the cabinet base.
- The hardware (hinges and pulls).
- Any peeling, wear, grease, or water damage.
Island (at least 4 photos)
- The island from the kitchen side.
- The seating side or back panel.
- Each section up close.
- One door or drawer up close.
- Any damage.
Bathroom vanities (at least 3 photos)
- Each vanity whole and straight on.
- One door or drawer up close.
- The hardware.
- Any water damage or swelling.
Laundry (at least 3 photos)
- Each wall of cabinets straight on.
- Each section up close.
- One door up close.
Built-ins (at least 3 photos)
- The whole built-in straight on.
- Each section up close.
- One door or shelf edge up close.
- Any damage.
What happens next
Good light helps. Add your city or ZIP code if we do not already have it. We typically send a written proposal within 24 hours of usable photos. A person from our team writes every proposal.
Need help with the form? Call 219.299.0080.
Before the door-removal visit
- Empty any drawers whose fronts do not come off the drawer box.
- Set out any new pulls or knobs you want installed, in a clearly labeled bag.
- Leave a clear path to the kitchen, and note any pets or access instructions.
Most cabinets can stay full. There is no need to empty them for this visit.
Before Day 1 on site
- Clear all countertops before we arrive.
- Empty the top row of cabinets if they are open to the ceiling.
- Empty open cabinet boxes with no door (a microwave niche or glass display), or glass door fronts if they are being refinished inside.
- You do not need to empty other cabinets or drawer boxes. Please leave a clear path to the work area.
Tell us before we start
Let us know about kids, pets, or any sensitivities, so we can plan around them. Your project-specific instructions confirm exactly what applies to your kitchen.
Send us a photo of your kitchen. We’ll take it from here.
A few photos are all it takes to begin. Your personalized quote typically arrives within 24 hours.
Send Photos for a Quote